All TIG Functions included
Maintenance and Repair
DC TIG (GTAW)
AC TIG (GTAW)
MIX TIG (GTAW)
Rated Output at 40℃ (104℉):
200A at 18V @60% Duty Cycle
1. Welding Process
DC TIG / AC TIG
MIX TIG / DC MMA
2. Memory Display
4. Ammeter/Voltmeter Display
5. Encoder Control
6. AC Waveshape types
7. Arc Ignition type
8. Pulser Control
Pulse Frequency 0.2Hz~200Hz
Pulse Width (Ratio) 1~100%
Base Current 5A~250A
Peak Current 5A~250A
2T(STD) / 4T(HOLD) / REMOTE
Arc-starting Current: 10A~160A
Crater-filling Current: 5A~160A
Current Up-slope Time: 0.1S~10S
Current Down-slop Time:0.1S~15S
11. Pre-Gas Time: 0.1S~10S
Flow-Gas Time: 0.1S~15S
12. AC Waveshape types
Advanced Squarewave / Soft Squarewave
Triangular Wave / Sine Wave
13. Arc Ignition Polarity: DC+ / DC-
14. MIX TIG
MIX Frequency: 0.1Hz~5Hz
DC Balance: (%) 10~90
15. AC Waveshape
AC Frequency Range 20Hz~200Hz
AC Clean Width (AC Balance) +40~-40
AC Clean Ratio (AC Bias) % +30~-50
The AC current can get a very good clearance, and DC current can get a deeper penetration. Use the MIX TIG we can get an excellent Arc Concentration, can be carried out the excellent welding performance from thin to thick plate.
1) Nice weld appearance, deep penetration.
2) Excellet Arc Concentration..
3) Substantially reduce the electrode consumption.
the cycle time of MIX
TIG in 1 second. Adjustable range: 0.1-10Hz..
DC Balance (%) = (tad/Tmix) x 100
Controls the width of the Controls the width of the arc cone.
Increasing the AC Frequency provides a more focused arc with increased directional control.
Note: Decreasing the AC Frequency softens the arc and broadens the weld puddle for a wider weld bead.
Controls arc cleaning action. Adjusting the % EN of the AC wave controls the width of the etching zone surrounding the weld..
Note: Set the AC Balance control for adequate arc cleaning action at the sides and in front of the weld puddle. AC Balance should be fine tuned according to how heavy or thick th eoxides are.
Allows the EN and EP amperage values to beset independently. Adjusts the ratio of EN to EP amperage to.
precisely control heat EN amperage controls the level of penetration, while EP amperage dramatically effects the arc cleaning action along with the AC Balance control.
The Pulsed TIG function switches the amperage from a high(peak) to a low(background) at a set rate(PPS). Pulsing can reduce heat input by lowering the average amperage,increasing control of the weld puddle, penetration and distortion. The following parameters can be adjusted for desired results:
1 to 10 pulses per second(PPS) will produce a distinct ripple pattern in the weld bead. Can be used to time filler addition,reduce distortion and improve control.
100 pulses per second(PPS) and higher helps to focus the arc for increased stability, penetration an d travel speed. Increased puddle agitation improves weld microstructure.
Get updates on sales specials and more
We want to hear from you!
Copyright © 2010 - 2017 www.cn-topwell. All Rights Reserved